TYP901 Banner

Announcement

Collapse
No announcement yet.

Fix the lazy panel shops mistakes

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Fix the lazy panel shops mistakes

    Wet and windy today so tackled the project that was most annoying me on my recently re purchased 911E

    Typical of a lazy panel shop after doing some minor paint repairs for the previous owner they made no attempt to tuck the side sill trim in behind the jacking point on either side of the car instead they bent both to basically cover the jacking point.

    One side the jack point is a little domed on the top (like a lot are after jacking the car up a few times) and that took a little more finessing and a little filing of the trim to get it to tuck behind like it should.

    One of the rubbers slid easily along the trim the other fought me all the way. Had to replace one with an old one I had as it was all cracked.

    For those of you wondering yes all the screws are now straight too.

    Job done.

    2023-04-15 12.47.41.jpg 2023-04-15 13.37.13.jpg
    Last edited by Terminator; 16-04-23, 08:47 AM.
    Clyde Boyer
    TYP 901 Register Inc.
    President
    Early S Register Member #294


    #2
    Bill A.

    72E Sporto (still is)

    Comment


      #3
      Looking good.
      It’s all of the 1% jobs that ultimately add up.
      Mark Branson
      1969 Australian Delivered 911 ST Replica.
      TYP901 Register # 349

      Comment

      Working...
      X