New Go Fast bits seen at GAF

[e72phil]

Hi guys,

take a look at this beautiful piece of CNC machining of custom throttle bodies to suit early MFI cars. They use the std injectors and can be run open or with teh air cleaner as pictured.

These pics are of the prototypes and I am hopeful of getting a set out here soon to show and maybe install on an MFI engine soon.

These should be a lot cheaper than some of the exotic stuff being made in low volume over in the US at present like the RSR slide bodies recently seen on the Early S site.

[Earlysport]

Hey Phil,

That looks a lot like an EFI fuel rail and injector bosses, but I guess they could be run with MFI too?

Is there any benefit to running something like this over the factory MFI throttle bodies ( assuming they aren't worn to the point of being unservicable ) ?

Craig H
-------------------
69 911E RS Replica 3.0L Webers 915
69 911E Stock
82 911SC IROC 3.8L Project
93 968CS Daily Driver

[CamBiscuit]

Porsche Porn

Phil you are a bad influence...

[e72phil]

Craig, Yes you're right about the fuel rails etc and this setup wasnt for an MFI car. Am checking on availability and price for MFI cars.

And Cam, not sure if there is a battery powered model .....???

[CamBiscuit]

Too many holes for me to cope with I think Phil!!!

[griffiths_r]

filth phil... absolute filth.

so, adding it to your stock list?!?

[IXXI72]

Get the drawings & we could make them for you Phil! Would be lighter in Titanium!!