Inertia Reel Seatbelts for 1973 911 E

[carl888]

My patience is waning with the fixed belts in the 911 E. Whilst I don't mind the operation so much, I've tripped over them exiting the car a few times, and operating the glovebox whilst belted in is a pain.

I've had belts made before by Hemco and haver been very pleased with them.

Questions:

1. If you fit inertia reel belts, what/where do you use as the anchorage points for the reel?

2. Anyone bought anything off the shelf?

Thanks for any information.

CJ

[Terminator]

Carl

Check under the rear wheel arch to see if the threaded part for inertia reel for seat belts exists on UK cars located in the mid point
of the rear 1/4 panel might be an Aussie thing though

[HughH]

Carl
Clyde is correct but I think that by 73 the UK cars had the fitting for the inertia reel
You can feel for it from the inside as well but you may have to remove the quarter panel inside
this is where mine is for reference

I used these guys recently for the replacement of my belts but because I already had all the hardware they used all of it and only replaced the webbing and reel mechanism

https://seatbeltsolutions.com.au/

interior 2011 001.jpg