Hoping someone can help with a photo and measurements I can use to repair my dash. It's been attacked with a hack saw around the radio area. Cheers. Tim
Announcement
Collapse
No announcement yet.
69 dash template
Collapse
X
-
Click the link in my signature for lots of 69 resto photos
Here for some dash shots... http://www.typ901.org/showthread.php?t=2645&page=42John Forcier
1969 2.7RS spec 911B(astard)
1968 2.0S spec 911 Race Car
Restoration Saga
1962 CB77 P3 TT Race Bike (looking for another engine)
-
Thanks Clyde, measurements of both heater control and radio hole cut outs would be great. And some close up photos to replicate the edge detail for the rebuild would be great. I have the centre support frame to guide us on the hole locations but want to get the hole sizes and detail correct.
Cheers
Tim
Comment
-
Thanks Clyde, while you have the camera can I trouble you for a shot like this. It's the view of where the door sill meets the front of the rear guard/body. I can see into the sill tunnel on both sides from inside the rear wheel arches and that's not right. If your rear wheels are back on it might not be possible. Cheers. TimAttached Files
Comment
-
Radio hole is 183mm wide and 53mm deep as best as I could measure. If you install your heater lever system you can figure where it stops on the LHS as it fits very tightly in the hole and the RHS looks original from the pic
What else do you need I think I have the idea of the photo you took and as you suspect there is no hole in my car...or anybody elses I suspect.Clyde Boyer
TYP 901 Register Inc.
President
Early S Register Member #294
Comment
Comment