Announcement
Collapse
No announcement yet.
I said never again...but I mispoke (lied)
Collapse
X
-
More restored bits no one in Australia does the fan re riveting correctly but it is about to be attempted on my fan to see if we can match factory look 15mm x 5mm countersunk aircraft alloy rivets is what is required to secure it in place correctly.
2020-01-28 12.50.57.jpgClyde Boyer
TYP 901 Register Inc.
President
Early S Register Member #294
Comment
-
More fancy work, this plater copper plates first for that awesome finish.
2020-01-29 15.59.43.jpg2020-01-29 15.59.52.jpg
2020-01-29 15.59.59.jpg
Clyde Boyer
TYP 901 Register Inc.
President
Early S Register Member #294
- Likes 3
Comment
-
1116DD13-2712-4D73-851C-C2C6C6B23F46.jpeg
A853C94B-2DEE-4F21-A34C-7517C7E84D16.jpeg
No Marcus plating all done at a different shop which I can recommend does good work
Thanks to a club member for supplying some correct alloy rivets and to David Belford for making a jig to install them correctly I now have a fan that looks new and factory correct again.Last edited by Terminator; 02-03-20, 07:29 PM.Clyde Boyer
TYP 901 Register Inc.
President
Early S Register Member #294
Comment
-
You don't often see these numbers on an old 915 gearbox as that bottom bar gets slaughtered as it is the closest point to the road.
Gearbox clean up happening, hard work though, too many cavities, too much cosmoline and too much tar and road grime.!!
2020-03-07 16.24.03.jpg2020-03-07 16.24.29.jpgLast edited by Terminator; 07-03-20, 04:40 PM.Clyde Boyer
TYP 901 Register Inc.
President
Early S Register Member #294
- Likes 2
Comment
Comment